Loading ...
Loading ...
Loading ...
10
USING YOUR BEER DISPENSER
Tap Equipment and Assembly
Your dispensing kit includes the following parts:
Polished stainless steel tower with clear beer line (single
or double dispense)
Tower Gasket
Phillips oval head screws
Knob for Tower (Faucet Handle)
Keg coupler(s)
CO2 regulator with red gas line(s) attached
Empty 5 pound CO2 tank
Plastic clamp(s) large and small
Faucet wrench
Tools required for installation:
Flat bladed screwdriver
Phillips screwdriver
Pliers
Adjustable wrench or a 1
1
⁄8" open end wrench
1
⁄2" open end wrench
Barrel Sizes
1/6 barrel 1/4 Barrel 1/2 Barrel
Height
23
5
⁄16"
(59.2 cm)
14
13
⁄16"
(37.6 cm)
23
5
⁄16"
(59.2 cm)
Diameter
9
1
⁄4"
(23.5 cm)
17"
(43.2 cm)
17" to 17
1
⁄4"
(43.2 to 43 cm)
Gallons 5.16 7.75 15.5
#12 ounce
Glasses
60 82 163
This beer dispensing unit will support
1
⁄2 barrel or
1
⁄4 bar-
rel. The double draft tower units can support two sixth (
1
⁄6)
barrels of beer. See chart below for quantity of beer in each
barrel size.
Table A
Table B
Keg Size
#of kegs per
5 pound CO2 Tank
5 gallon Corny 15 to 22
1/6 barrel 14 to 21
1/4 Barrel 10 to 14
1/2 Barrel 5 to 7
CO2 can be dangerous. If it becomes difcult to
breathe and/or your head starts to ache, a high
concentration of carbon dioxide may be present.
Leave the area immediately.
• The CO2 tank must always be connected to the
regulator. Never connect the tank to the keg.
• The CO2 tank must be securely mounted in the
upright position. Secure it with the chain pro-
vided.
• Never drop or throw the CO2 tank.
• Keep the CO2 tank away from heat.
• Ventilate the area after a CO2 leak.
!
WARNING
1. Remove shelving and packaged components from the
interior of the refrigerator before beginning the assem-
bly process.
2. Take your empty 5 pound CO2 tank to your local gas
supply dealer to be lled. You can usually nd them in
your "yellow pages" under "Welding Supply" or "Fire
Protection". One 5 pound tank can process many kegs
(see table "B") Your dealer should supply you with a
new plastic washer every time the tank is lled. This
washer is used at the regulator to tank connection. See
Figure 15 and 22 on page 11. Replace the old washer
with the new one whenever the tank is relled.
3. Tower mounting (if you are installing the unit under a
counter skip to step 4). If you are mounting the tower
directly to the top of the refrigerator, rst remove the
four screws from the top of the refrigerator. Feed the
clear beer line through the tower gasket and the large
hole in the refrigerator top. Align the 4 holes in the
tower with the 4 holes in the refrigerator top and secure
the tower with the 4 screws removed previously. Skip to
step 5.
Loading ...
Loading ...
Loading ...