Loading ...
Loading ...
Loading ...
22
Replace Left-Hand Refrigerator Door
IMPORTANT: Do not intertwine the water tubing and wiring
bundles when reconnecting them
1. Set the left-hand door onto the bottom hinge pin.
2. Fasten the hinge to the cabinet. Do not tighten the screws
completely.
3. If applicable, reconnect the water dispenser tubing.
Style 1 - Insert the tubing into the fitting until it stops and the
outer ring is touching the face of fitting.
Style 2 - Insert the tubing firmly into the fitting until it stops.
Close the clasp around the tubing. The clasp snaps into place
between the fitting and the collar.
4. Reconnect the electrical wiring.
� Push together the two sections of the wiring plug.
Final Steps
1. Completely tighten the internal screws
2. Replace both top hinge covers.
Remove and Replace Refrigerator
Drawer
Depending on the width of your door opening, it may be necessary
to remove the drawer fronts to move the refrigerator into your
home.
REMOVE DRAWER FRONT
IMPORTANT:
� If the refrigerator was previously installed and you are moving
it out of the home, before you begin, turn the refrigerator
control Off, and unplug the refrigerator or disconnect power.
Remove food and any adjustable door or utility bins from
doors.
� Two people may be required to remove and replace the
freezer drawer. Graphics are included later in this section.
Tools Needed: 1/4" Hex head nut driver, Flat-blade screwdriver
Disconnect Wiring (if applicable)
NOTES:
� The exterior refrigerator drawer front is connected to the
temperature control on some models. Before removing the
drawer front, the wires must be disconnected from the
temperature control.
� The gray cable visible behind and under the pantry drawer at
the right side contains wiring for the pantry control and moves
with the drawer as it is pulled out. There is no need to
disconnect this cable.
1. Open the drawer to its full extension, and remove the interior
bin.
2. Left-hand drawer only: Remove the wiring connection cover.
Press in on the side of the cover to release the tab from the
slot, and then pull the cover away from the bracket.
A. Cover tab B. Wiring connection cover
3. Left–hand drawer only, disconnect the wiring.
NOTE:
� On one side of the wiring connector, insert the screwdriver
blade between the connector tab and the connector to
release. Repeat for the opposite side. Pull the wiring
connector apart.
4. Remove the drawer front.
Style 1: Bottom Release Lever
� Push up on the lever at the bottom of the drawer glide bracket
to release the drawer front from the bracket.
� Lift the drawer front up and off the drawer glide brackets.
A. Drawer glide bracket B. Release lever
Style 2: Bottom Screws
� Loosen the two top screws attaching the drawer glide brackets
to the drawer front.
NOTE: Loosen screws three to four turns. Keep the screws in
the drawer front.
� Remove the two bottom screws attaching the drawer glide.
� Lift the drawer front up and off the top screws.
A. Four Bracket screws
5. Slide the drawer glides back into the refrigerator.
Loading ...
Loading ...
Loading ...