WTW4950HW1 User Manual

Loading ...

PROGRESS LIGHTS

The Progress Lights show the progress of a cycle. At each

stage of the process, you may notice sounds or pauses

that are different from traditional washers.

SENSING/FILL

When the Start/Pause/Cancel button is pressed

and the Water Level knob is set to Auto Sensing, the

washer will ll and begin sensing to determine load

size and balance. A short but noticeable pause in the

cycle action occurs during sensing. This is normal.

Once sensing is complete, the washer will ll to the

appropriate level for the detected load size and, on

select cycles, agitation will occur during lling. This,

too, is normal. When the washer is done lling, it will

begin the wash phase of the cycle. To ensure that

the most accurate load size is detected, avoid opening

the lid during the “Sensing” phase.

NOTE: Sensing and wash phases will be paused by

opening the unlocked lid. Close the lid to resume the

cycle. If the lid is left open for more than 10 minutes,

the washer will cancel the cycle and pump out the

water.

WASH

The washer will ll to the correct water level based

on the load size and the Water Level selection. Certain

cycles may agitate during the ll process to boost

cleaning. When the wash cycle begins, you will hear

the impeller increase speed. The motor sounds may

change at different stages in the wash cycle while the

washer performs different wash actions.

NOTE: The lid will automatically lock after the wash

phase completes and before the initial spinout occurs,

and will remain locked for the rest of the cycle.

RINSE

Certain cycles use a spray rinse, which adds water

to the tub while the basket spins. You may hear the

motor turning on briey (short hum) to move the basket

while lling. In some cases, you may also hear sounds

similar to the wash cycle as the washer lls, rinses,

and moves the load.

FINAL SPIN

The washer spins the load at increasing speeds for

proper water removal based on the selected cycle

and spin speed.

CYCLE COMPLETE

Once the cycle is complete, the lid will unlock and this

light will come on. For best results, remove the load

promptly.

LID LOCKED

The Lock feature allows for higher spin

speeds. When lit, the lid is locked and

cannot be opened without pausing the

cycle. When the light is off, the lid can

be opened.

To open the lid after it has been

locked, press START/PAUSE/

CANCEL. The lid will unlock once the

washer movement has stopped. This

may take several minutes if the load

was spinning at high speed. Press

START/PAUSE/CANCEL while the lid

is closed to resume the cycle.

Appearance

may vary

Loading ...

User Manual - Page 5