Loading ...
Loading ...
Loading ...
ntenance and Care
Replace drive belt
1. Turn the power switch off and unplug
the vacuum from the electrical outlet.
Remove floor brush following steps 2-4
on page 14.
2. With the rotating floor brush removed
from the vacuum cleaner, grasp the old
drive belt and remove from the motor
pulley. Discard the old drive belt.
3. Place the new drive belt over the motor
pulley oass the belt through the open-
ing of'the belt ON/OFF mechanism
and loop the belt over the rotating floor
brush in the space between the bristles.
NOTE: It is important that you use
only genuine BISSELLreplacement
belts. Generic belts many not meet
the exact specifications required
to keepyour vacuum operating at
its peak performance. The use of .
unbranded belts could lead to early
failure of the vacuum and could
void your warranty.
4. Place ends of the rotating floor brush
down into the slots on the sides.
Alignment of brush ends is necessary
to ensure the brush is fully inserted. -
5. Turn the rotatin_ floor brush by hand
several times. 1Tproperly installed,
the drive belt will center itself on the
rotating floor brush crown.
6. Place the brush cover back and secure
with its screws.
2.
6.
pulley
15
www. bi s se II. co m _, 800.237.7691
Loading ...
Loading ...
Loading ...