Loading ...
Loading ...
Loading ...
22
© 2021 United States Stove Company
Stove Feeds Pellets, But Will Not Ignite
Possible Causes Possible Remedies: (Unplug stove rst when possible)
Air damper open too far for ignition.
In some situations it may be necessary to have the damper
completely closed for ignition to take place. After there is
a ame, the damper can then be adjusted for the desired
feed setting.
Blockage in igniter tube or inlet for igniter
tube.
Find the igniter housing on the backside of the rewall.
The air intake hole is a small hole located on bottom side of
the housing. Make sure it is clear. Also, look from the front
of the stove to make sure there is not any debris around
the igniter element inside of the igniter housing.
The burnpot is not pushed completely to
the rear of the rebox.
Make sure that the air intake collar on the burnpot is
touching the rear wall of the rebox.
Bad igniter element.
Put power directly to the igniter element. Watch the tip
of the igniter from the front of the stove. After about 2
minutes the tip should glow. If it does not, the element is
bad.
The control board is not sending power to
the igniter.
Check the voltage going to the igniter during startup. It
should be a full current. If the voltage is lower than full
current, check the wiring. If the wiring checks out good,
the board is bad.
Smoke Smell Coming Back Into The Home
Possible Causes Possible Remedies: (Unplug stove rst when possible)
There is a leak in the vent pipe system.
Inspect all vent pipe connections. Make sure they are
sealed with RTV silicone that has a temperature rating on
500 degree F or higher. Also, seal joints with UL-181-AP foil
tape. Also, make sure the square to round adapter piece
on the combustion blower has been properly sealed with
the same RTV.
The gasket on the combustion blower has
gone bad.
Inspect both gaskets on the combustion blower to make
sure they are in good shape.
Because it is a wood-burning device, your pellet heater may emit a faint wood-burning odor. If this
increases beyond normal, or if you notice an unusual soot build-up on walls or furniture, check your
exhaust system carefully for leaks. All joints should be properly sealed. Also clean your stove, following
instructions in “MAINTENANCE”. If problem persists, contact customer service.
TROUBLESHOOTING GUIDE
Loading ...
Loading ...
Loading ...