Loading ...
Loading ...
Loading ...
24 25
24 25
STORAGE (FIG. K, L, M)
Rip fence, miter gauge (Fig. K)
Storage brackets for the rip fence (2)
and miter gauge (3) are located on the
left side of the saw housing.
NOTE: Adjust the miter gauge to
45º~60º before putting away in storage.
Blade Wrench (Fig. L)
Insert the blade wrench into the
slot (4) located to the back side of the
saw housing.
Blade (Fig. M)
1.
Loosen and remove the knob (1) on
the right side of the saw housing.
2. Place extra blades (not included)
onto the arbor. Replace the knob (1)
and tighten.
4
Fig. L
ASSEMBLING THE HANDWHEEL
HANDLE (FIG. N)
Thread the handwheel handle (1) into
the handwheel hole, and then tighten
the nut against the handwheel with a
14 mm or adjustable wrench.
INST
ALLING TABLE SIDE
EXTENSIONS (FIG. O)
1. Identify the right hand table
extension.
NOTE: For illustration purposes, the
view in Fig. O looks “through” the
saw table to the under side of the
table. The right hand table extension
is the one with the measuring scale
visible from the front of the saw
when it is installed to the right hand
side of the saw table.
2. Unlock both front and rear cam
locking levers (1) on the right hand
side of the saw base by flipping the
levers over.
3. Insert the table extension mounting
tubes (2) into the two matching
holes in the cam lever assemblies.
NOTE: Make sure the front
mounting tube has the measuring
scale visible from the front of
the saw.
Fig. M
1
Fig. N
1
Loading ...
Loading ...
Loading ...