Loading ...
Loading ...
Loading ...
20 21
20 21
ASSEMBLING THE ROLLER WHEEL
TO STAND (FIG. D, E)
1. Place stand upside down on level
surface or floor.
2. Place bottom support bracket for
roller wheel (18) inner of the front
leg (2).
3. Insert the bolt (12) through the roller
wheel bracket (11), front leg (2),
bottom support bracket (18) and
nut (13) as shown. Fully Tighten
the nut.
4. Attach the roller wheel (14) to roller
wheel bracket (11), bolt (15) and lock
nut (16) using square neck bolt (15)
and lock nut (16) as shown.
NOTE: Do not overtighten lock nut
as this will not allow the wheels
to turn.
5. Repeat steps 1-4 for left rear leg (17)
and roller wheel assembly.
NOTE: The roller wheel assemblies
and bottom support bracket (18)
can be installed on either the right-
hand side or left-hand side.
Always
install the roller wheel assemblies
and the bottom support bracket (18)
at the same time. The illustration
shows the roller wheels on the left-
hand side.
Fig. D
12
13
14
15
16
2
1
1
18
6. Carefully set the stand in its upright
position on a clean level surface.
ASSEMBLING THE FOOT PAD TO
ST
AND (FIG. F)
1. Place all four foot pads (9) onto
each leg.
2. Place stand on level surface and
adjust so all legs are contacting the
floor and are at similar angles to the
floor, and detents in stand leg align
with support brackets. Once stand
is properly aligned, fully tighten
all bolts.
NOTE: Stand should not rock after
all bolts are tightend.
Fig. E
2
Front
18
17
Fig. F
9
9
Loading ...
Loading ...
Loading ...