Loading ...
Loading ...
Loading ...
Installation
To Install:
1. Pull both rails out to full
extension.
2. While supporting door front,
hook supports into tabs
located on inside of rail.
3. Lower door front into
final position.
4. Place the basket cradles back onto the side rails.
Align snaps with the slots on the side rails and
press each snap toward the rail until it clicks.
5. With rails pulled out to full extension, set the
basket straight down into the basket cradles.
Basket cradle
snap attachments
1. Install hinge assemblies:
• Install top hinge loosely with 5/,;, hex head
screws.
• Install center hinge with Phillips
screws.
2. Place hinge side of refrigerator door
on center hinge pin.
3. While holding refrigerator door .L
upright, tighten down top hinge
with F,_" hex head driver.
4. Reconnect two-pin connector.
5. Replace top hinge covers.
f
W
Handles
Note: If not installed, the handle is located in the
interior of the fresh food section or attached to the
back of your refrigerator.
Remove and discard handle packaging and tape.
Plastic Handle
To Install:
1. The handles are to be oriented
as shown.
2. Align door handle clip with the
door studs.
6. Slide upper basket into freezer. Make sure that rear
of basket hooks behind rail catch.
J
J
Door Reinstallation
Materials Needed:
• Phillips screwdriver
• _" hex head driver
3. Ensure the large hole in the
mounting clip is positioned
down on both ends of the
handle.
9or
Stud
4. Rotate the handle so that the
handle is flat against the door.
Loading ...
Loading ...
Loading ...