Loading ...
Loading ...
Loading ...
Installation
Door and Drawer Removal
Some installations require door/drawer removal to
transport the refrigerator to its final location.
Materials Needed:
• Phillips screwdriver
• _6" hex head driver
• %" hex head driver
1. Unplug power cord from power source.
• Lift left side refrigerator
door, along with top hinge,
from center hinge pin.
• Remove center hinge pin
with a _6" hex head driver
and retain hinge pin for later
use.
8. Remove Phillips screws to remove right and left
hinges and retain all screws for later use.
9. Remove both stabilizing brackets with 3/;,hex head
driver and retain screws for later use.
Pullout Freezer Drawer
2. Remove toe grille (see page 3).
3. Remove top hinge cover from
refrigerator door by removing Phillips
screw and retain screw and cover for
later use.
4. Unscrew _,_" hex head screws from
top hinge to remove hinge and retain
all screws for later use.
5. Lift right side refrigerator door from
center hinge pin. Remove door
closure from center hinge pin on the
. right
right side and retain for later use. side
6. Disconnect wire harness on top _. _ door
of left side refrigerator door top Iosure
hinge. ....
• Release two-pin connector by "
pressing junction point with a
flat blade screwdriver or
fingernail.
• Green ground wire remains
attached to the hinge. II
7. Unscrew _6" hex head screws from
top hinge to remove hinge and
retain for later use.
To Remove:
1.
2.
.
4.
Pull drawer open to full extension.
Pull upper basket out to full extension and lift out
to remove.
Lift lower basket straight up and out to remove.
On each side rail is a basket cradle
with two snap attachments. To
release each cradle, unlatch the
snaps by pushing them inward,
away from the side rail system. Lift
the cradles off of the rails.
Lift top of drawer front to unhook
supports from rail system. Lift door
front out to remove.
Loading ...
Loading ...
Loading ...