Loading ...
Loading ...
Loading ...
Totest thefunctionof theforwarddrive bail,lift the bailto the handle
andreleaseit. The bail shouldreturnto its neutralposition.Ifit doesn't,
contactCustomerSupportfor assistanceorthe nearestdealer.
4. Snapthe cablehousingclips intothe handleassemblycable
mount.The red clip (reversecable)fits into thetop positiononthe
handleassembly,whilethe black clip (forward/clutchcable)feeds
intothe lowerpositionon the handleassembly.See Figure3.
Red
Reverse
Figure3
Clipthe cablesintothe cableguideslocatedon the handle
assemblypanelas seenin Figure4.
MOVING THE TILLER OFF THE SKID
To roll thetiller off the shippingplatform,put thewheels infreewheel,if
theyarenot alreadyfrom the factory,as follows:
1. Placea sturdyblockunderthe transmissionto raiseonewheel
about 1"off the ground.Removethe clickpin fromthe wheelhub
andwheelshaft. See Figure5.
f
Click Pin
Remove the click pin
from the wheel hub.
(WHEEL DRIVE position)
Slide the wheel fully
inward on the wheel shaft.
Reinstall the click pin.
(Freewheel position)
Figure5
2. Slidethe wheelfullyinwardonthe wheelshaft. Reinstallthe click
pinthroughthe wheelshaftonly (notthroughthe wheelhub). See
Figure5. Thewheel shouldnow spinfreely(freewheel)onthe
wheelshaft. Repeatwith theother wheel.
3. Usethe handlebarto lift and pull the tillerbackwardsto a flat
area.
NOTE:Beforestartingthe engine,the wheelsmustbe placedinthe
WHEELDRIVEposition(pinsthroughwheelhubsandwheel shaft).
Thisprocedureisdescribedinthe operationsectionunderwheeldrive
pins.
Figure4
J
8
Loading ...
Loading ...
Loading ...