Loading ...
Loading ...
Loading ...
2. Connectone end of the BLACKcable
to the NEGATIVE(-) terminal (C)of
fully charged battery.
3. Connectthe other end of the BLACK
cable (D) to goodchassisground,
awayfromfuel tank and battery.
TO REMOVECABLES,REVERSE
ORDER-
1. BLACKcablefirst from chassis and
then from the fully charged battery.
2. RED cablelast from both batteries.
Weak or Dead Fully Charged
Battery Battery
REPLACmNG BATTERY
AI_WARNmNG: Do not short battery
terminals by allowing a wrench or any
other object to contact both terminals at
the same time. Before connecting battery,
remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect BLACK battery cable
then RED battery cable and carefully
remove battery from tractor.
4. Install new battery with terminals in
same position as old battery.
5. Reinstall terminal guard.
6. First connect RED battery cable to
positive (+) battery terminal with hex
bolt and keps nut as shown. Tighten
securely.
7. Connect BLACK grounding cable to
negative (-) battery terminal with re-
maining hex bolt and keps nut. Tighten
securely
8. Close terminal access doors.
9. Close hood.
Terminal Ke
Access
Door ._,._, ,..
Terminal
Guard
Nut Hex BoUt
Positive
(Red) CaMe
TO REPLACE HEADUGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the
backside of the grill.
3. Replace bulb in holder and push bulb
holder securely back into the hole in
the backside of the grill.
4. Close hood.
mNTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
,, Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRmLL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
4. When replacing hood, be sure to re-
connect the headlight wire connector.
Headlight Wire
Connector
,gative (Black)
Cable 26
Loading ...
Loading ...
Loading ...