Loading ...
Loading ...
Loading ...
ASSEMBLY
CAUTION: Carefully read and follow step 1 below before removing the restraining tie (see drawing 1
below). If the restraining tie is removed prematurely, serious bodily injury may result. Assembly requires
two people. Set the treadmill in a cleared area and remove the packing materials, except for the restraining tie.
Do not dispose of the packing materials until assembly is completed. Assembly requires the following tools (not
included): A phillips screwdriver ,,_ and a 3/8" wrench '_ O.
.
Slide the Left Upright (1) onto the left side of the Base
(55). It may be necessary to firmly push down on the
Left Upright until it Is fully seated on the Base.
Remove the restraining tie from the Base.
Using a 3/8" wrench, tighten two of the four Upright
Screws (50) into the Left Upright (1) and the Base (55). Be
sure to push on the heads of the Upright Screws while
tightening them.
5O
55
RestrainingTie
.
Slide the Right Upright (43) onto the right side of the Base
(55). It may be necessary to firmly push down on the
Right Upright until it is fully seated on the Base. Be
careful not to pinch the Wire Harness (19) between
the Right Upright and the Base.
Using a 3i8" wrench, tighten two Upright Screws (50) into
the Right Upright (43) and the Base (55). Be sure to push
on the heads of the Upright Screws while tightening them.
Remove the wire ties (not shown) attaching the Console
(9) to the Right Upright (43).
9
5O
55
.
Set the Console (9) on the Left and Right Uprights
(1, 43). Attach the Console with four Console Screws (7).
While one person carefully feeds any slack Wire Hamess
(19) down into the Right Upright (43), a second person
should carefully pull the slack Wire Harness from the
lower end of the Right Upright.
5
Loading ...
Loading ...
Loading ...