Control4 C4-APD120-WH White 120V Adaptive Phase Dimmer C4APD120WH

User Manual - Page 3

For C4-APD120-WH.

PDF File Manual, 4 pages, Read Online | Download pdf file

Loading ...
Loading ...
Operation and configuration
On initial power up, all status LEDs on the dimmer will illuminate green, indicating
that the device has power. To set up this dimmer for use with a Control4 system,
refer to the Composer Pro User Guide.
To operate this dimmer as a stand-alone device:
• Click the top button to turn the light on.
• Click the bottom button to turn the light o.
Press and hold the top button to ramp the light up. Release the button at the
desired light level.
Press and hold the bottom button to fade the light down. Release the button
at the desired light level.
Air gap switch
During routine lamp replacement, you should remove power from the lamp by
engaging the air gap mechanism. If using Contemporary faceplates, remove the
faceplate to access the air gap switch.
1 To engage, press on the right side of the top actuator bar until the left side
pops out. All LEDs on the dimmer will turn o, and the dimmer will no longer
control the light when the air gap mechanism has been engaged.
2 To return power to the dimmer and lamp, press on the left side of the top
actuator bar until it snaps back into place.
Figure 3. Dimmer with actuator bar
Button tap sequences
The button tap sequences are defined in the table below. Button tap sequences
that require a single button should use the top button.
Function Button sequence
Identify 4
Zigbee channel 7
Reboot 15
Factory reset 9-4-9
Leave mesh and reset 13-4-13
Actuator bar for
air gap switch
Curved edge faces
top of keypad
Troubleshooting
If the light does not turn on:
Ensure that at least one LED on the face of the dimmer is lit.
Ensure that the light bulb is not burned out and is screwed in tightly.
Ensure that the circuit breaker is not turned OFF or tripped.
Check for proper wiring (see “Sample Wiring Configurations”).
Care and cleaning
Do NOT paint the dimmer or its wall plate.
Do NOT use any chemical cleaners to clean the dimmer.
Clean surface of the dimmer with a soft damp cloth as needed.
Warranty and legal information
Find details of the product’s Limited Warranty at
snapav.com/warranty
or request
a paper copy from Customer Service at
866.424.4489
. Find other legal resources,
such as regulatory notices and patent information, at
snapav.com/legal
.
Sample wiring configurations
Figure 4. Single device location, with neutral connection (recommended)
Figure 5. Single device location, without neutral connection
Loading ...