Loading ...
Loading ...
Loading ...
_Ib WARNING: If the auxiliary fence is
not used when the saw arm is in the 0 °
crosscut position, the molding head can-
not be located behind the fence for safe
and proper operation.
t
3. Remove saw blade, dado, or
sory from the sa_ arbor shaft be{ 1
the accessory shaft. Do not use th_saw
*1
accessories installed on both endS,ofxhe sawJ
arbor shaft at the same time.
4. Edging can also be done in the 30 ° left
miter without the use of an auxiliary fence.
Follow the instructions below.
4. Make sure the unused shaft is covered by a
guard, the arm, or the screw cap to avoid
being pulled into moving parts by hair,
threads, clothing.
• Miter the arm to the left approximate-
ly 30 °.
• Swivel the motor until bottom of
motor is parallel to and facing the rip
fence and operating instructions label
is visible.
5. Drill chucks can bend and pieces of the
drill bit can break. You can be blinded or in-
jured if hit by thrown pieces. Do not use twist
drills longer than 7 inches.
6. Use a spade type drill of 1 inch diameter
or smaller. Use for drilling only wood or plas-
tic because the speed is not high enough for
other types of materials.
• Follow all steps outlined on motor
label as shown below.
Fig. !10 - Edging Label
Accessory Safely
7, Do not use other reduced shank drills.
8. Remove adjusting wrenches. Form habit of
checking to see that adjusting wrenches are
removed from tool before turning it on.
9. When using the accessory shaft in the verti-
cal position, swivel the motor 90 ° so that the
arbor shaft is under the radial arm as shown.
,WARNING: Clothing, hair, jewelry can
be caught and pulled into an exposed
arbor shaft. Fingers, hand or arm can be
broken or cut off. Place the arbor shaft
under the radial arm when using the ac-
cessory shaft.
1. For your safety use only recommended ac-
cessories. Use of any other accessories may
increase the risk of injury. See Recom-
mended Accessory section of manual.
2. Use of grinding wheels, abrasive or cut off
wheels, or wire wheels is dangerous because
they can break explosively and throw pieces.
You can be blinded or recieve a life threaten-
ing puncture wound. Do not use grinding
wheels, abrasive/cut off wheels or wire wheels.
Fig. 111- Arbor Shaft Position When Using
Accessory Shaft
51
Loading ...
Loading ...
Loading ...