Loading ...
Loading ...
Loading ...
6
Installation
English
What’s in the Box
Make sure you have all the following items
included in the packaging. If any item is
damaged or missing, contact your dealer.
− Power Converter/Battery Charger x 1
− Instruction Manual x 1
− Warranty Card x 1
Mounting Location
The Furrion power converter/battery charger
can be mounted in any position within an
enclosed compartment. Provide sufficient
air space to allow unrestricted airflow in and
around the unit.
The power converter should be installed in
an environment that meets the following
requirements:
● DRY Do not allow water to drip on or
enter into the converter.
● COOL Ambient air temperature should
be between 0°C and 40°C, the cooler the
better.
● SAFE Do not install the converter
in a battery compartment or other
areas where volatile fumes may exist,
such as fuel storage areas or engine
compartments.
● VENTILATED Keep the converter
a minimum of 25mm away from
surrounding objects. Ensure the
ventilation area of the unit is not
obstructed.
● DUST Do not install the converter in
dusty environments. Dust can be inhaled
into the unit when the cooling fan is
working.
● FUSED A fuse must be applied between
the battery and the converter.
● CLOSE TO BATTERIES Avoid excessive
cable lengths. Do not install the converter
in the same compartment as batteries.
● Use the recommended wire lengths and
sizes.
● Do not mount the converter where it will
be exposed to the gases produced by the
battery. These gases are very corrosive,
and prolonged exposure will damage the
converter.
Mounting the Converter
IMPORTANT: Always disconnect the positive
side of the battery before installation.
The power converter/battery charger is
designed with four slots in its mounting
bracket that allows the unit to be fastened
against a bulkhead, floor, wall or other flat
surface.
Connecting the Converter
There are no components within the power
converter/battery charger that, in their
normal operation, produce arcs or sparks.
However, all electronic devices have some
potential for generating sparks in the event
of failure. Therefore, never install this device
in the same compartment with flammable
items such as gasoline or batteries.
Connecting to a Power Source
Plug the power converter/battery charger
AC input cord into a 120V 3 wire grounded
source:
● 5-15R socket for 60A converter.
● 5-20R socket for 80A converter.
Loading ...
Loading ...
Loading ...