1217076 User Manual

Loading ...

B102218-5-1016Page 38

Although we have attempted to ensure that your grill will operate properly and satisfactorily, sometimes problems do arise.

The following troubleshooting guide lists several possible problems and their probable cause and solution.

Do not repair or replace any part of the grill unless specically recommended in this manual.

All other service should be referred to a qualied technician.

Problem Cause Solution

Burner will not light. Spider webs in venturi tubes Clean venturi tubes. See Maintenance Section.

Out of gas Rell LP gas cylinder. If natural model, turn on

gas at source.

Gas injector not inserted in

venturi tube

Realign/engage gas injector with the venturi

tube.

Clogged gas injector Remove gas injector from gas control assembly

and clean.

Obstruction in gas line For propane models, ensure gas valve on cylin-

der is OFF. Remove exible hose and blow out

any debris.

Misalignment of collector box

and burner

Position electrode properly. Clean collector box.

Dead battery Replace with AA Alkaline battery.

Inadequate grill temperature. Poor combustion Adjust air shutter.

Misalignment of venturi tube

and gas injector

Realign/engage gas injector with the venturi

tube.

Inadequate gas pressure Contact gas supplier for assistance.

Flames off the burner. Cold grill Preheat grill at least 5 minutes on HI with the

grill lid open.

Misalignment of burner tube

and gas injector

Realign/engage gas injector with the burner

tube.

Poor combustion Adjust air shutter.

Extreme wind Turn or shield grill.

Yellow ames. Air shutter improperly set Open air shutter.

Spider webs in venturi tubes Clean venturi tubes. See Maintenance Section.

Seasoning salts on burner Clean by washing burner with mild detergent.

Oil lm on burner Allow burner to operate on HI for 10-15 minutes.

Low heat with knob in "High" position. Check for proper gas supply and pressure.

Pre-heat grill for a full 15 minutes.

If using L.P. gas, check for empty tank.

Check for kinks in supply line.

If only one burner appears low, clean burner,

clearing ports of any obstructions.

Infrared back burner won't light. Check the burner inlet for obstructions.

Grill may be in a dusty area. Move to a less

dusty area if possible.

TROUBLESHOOTING

Loading ...

User Manual - Page 38