Loading ...
Loading ...
Loading ...
B102218-5-1016Page 34
Check for Gas Leaks
Check for gas leaks every time you connect your Broilmaster
propane gas grill to a Propane gas cylinder, when a connected
cylinder has not been used recently, or when either a natural or
propane grill is being used for the rst time.
WARNING
Do not use an open ame to check for leaks. Checking for
leaks with an open ame may lead to a re or explosion,
resulting in property damage or personal injury.
To check for gas leaks:
1. Use water dish and a little dish washing liquid to make a
soapy solution.
2. Turn OFF the knob on the control panel.
3. Turn ON the gas at the supply or cylinder. A hissing sound
indicates a leak. Turn OFF the gas and repair the leak.
4. Apply the soapy water solution to all gas connections.
5. Look for bubbles. Bubbles indicate a leak.
6. If you see bubbles turn OFF the gas and repair the leak.
7. Turn the gas back ON and repeat the above procedures until
all leaks are repaired.
Air Shutter Adjustment (R3B Series Only)
The venturi air shutter(s) are preset at the factory so that after
ve minutes the burner ames are blue with well dened cones.
If, after ve minutes the ame is yellow, or there is a gap between
the burner and the ame, adjust the venturi air shutter as follows:
1. Turn gas OFF and let the burner cool.
2. Beneath the control panel you can access the air shutter(s)
which are located on the end of the burner tubes.
3. Loosen shutter set screw.
4. Close the air shutter to the minimum opening.
5. Light the burner, wait ve minutes and then carefully open
the air shutter until the ame is blue and well-dened.
6. Retighten the set screw.
Operating Instructions
Lighting with the Electric Igniter
CAUTION
If a burner fails to light after 5 seconds, turn the burner
OFF for 5 minutes, to allow the gas to clear, then try again.
1. Open the grill lid.
2. Turn burner knob CLOCKWISE to the OFF position.
3. Turn ON the gas at the source.
4. With the grill lid open, push and turn the burner control knob
COUNTERCLOCKWISE to Hi.
5. Push and hold the igniter button until the burner lights
(approximately 5 seconds).
OPERATION - PROPANE AND NATURAL GAS GRILLS
6. If a burner does not light, turn OFF all gas and refer to the
Troubleshooting section of this manual.
7. Repeat steps 3 through 5 for other burner.
Lighting with a Match
CAUTION
If a burner fails to light after 5 seconds, turn the burner
OFF for 5 minutes, to allow the gas to clear, then try again.
1. Open the grill lid.
2. Turn the burner knob CLOCKWISE to the OFF position.
3. Turn ON gas at the source.
4. For Blue Flame grills, insert a burning long wooden match
through the lighter hole on the left side of the grill. See Fig-
ure Below. For Infrared grills, inserting the lighting stick
with a long wooden match attached through the cooking
grid to ignite the infrared burner from the top.
5. With the grill lid open, push and turn the burner control knob
COUNTERCLOCKWISE to HI.
6. If a burner does not light, turn OFF all gas and refer to the
Troubleshooting section of this manual.
7. Repeat steps 3 through 6 for other burner.
LIGHTING A MATCH BLUE FLAME BURNER
LIGHTING STICK
R734
KEEP HAND AWAY FROM
TOPOF GRILL WHEN LIGHTING
INFRARED BURNER
MATCH LIGHT HOLE
BLUE FLAME BURNER
S
LIGHTING WITH BLUE FLAME AND INFRARED BURNER
Loading ...
Loading ...
Loading ...