Loading ...
Loading ...
Loading ...
E ADJUSTME
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizonta! (!eft to right)
when wheels are positioned straightforward, removesteer-
ing wheel and reassemble per instructions in the Assembty
section of this manual.
FRONT WHEEL TOE++N!CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 27}
® Block up axle securely.
, Remove axle cover, retaining ring and washers to allow
wheet removal (rear wheel contains a square key - Do
not lose).
, Repair tire and reassemble.
• On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.
+ Replace washers and snap retaining ring securely in
axle groove.
+ Replace axle cover.
WASHERS
AXLE COVER
FIG. 27
TO START ENGINE WroTH A WEAK BATTERY
(See Fig. 28}
CAUTION: Lead-acid batteries gener-
ate explosive gases. Keep sparks, flame
and smoking materiaJs away from bat-
teries. A_ways wear eye protection
when around batteries°
If your battery is too weak to start the engine, it should be
recharged, if "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USEYOURTRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
, Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis.
+ Connect one end of the BLACK cable to the NEGA-
TIVE (-) terminal of fully charged battery.
- Connect the other end of the BLACK cable to good
TO REMOVE CABLES, REVERSE ORDER -
, BLACK cabte first from chassis and then from the fully
charged battery,.
, RED cable last from both batteries.
"POSITWE" (+}
"NEGATWE" (-}
FIGo 28
22
Loading ...
Loading ...
Loading ...