Loading ...
Loading ...
Loading ...
12.Removeiceservicerackbyliftingrackoffplastic
washersthenpullingout.Removescrewswitha
1/4"hexnutdriver.Insertplugsintoscrewholes.
Washer
\
1/4" (6 mm)
17. Remove water tube inlet hole plug on rear of
refrigerator cabinet with a screwdriver covered with
masking tape.
/
f
}
Water tube inlet hole plug ............................
13. Locate electrical and water connection cover plate
on upper left rear wall of freezer. Remove electrical
and water connection cover plate by removing
screw with a 1/4" hex nut driver. Discard electrical
and water connection cover plate and screw.
14. Insert oblong plug into cover mounting slot.
15. Remove freezer shelf by pulling out. A sharp tug
may be necessary. Remove basket by lifting and
pulling out.
16. Cut out sealing tape from water inlet tube hole,
located on back wall, with a knife covered with
masking tape.
Water inlet tube hole---
18. Cover end of water fill tube elbow with masking tape
to prevent insulation beads from entering water fill
tube elbow. Push water fill tube elbow through "U"
shaped hole on back of refrigerator cabinet. Pull
water fill tube elbow through hole in freezer.
Remove masking tape from end of water fill tube
elbow.
19. Push gently on water fill tube elbow while twisting
elbow slightly until elbow is firmly seated inside "U"
shaped hole.
Water fill tube elbow ...............
4
20. Remove ice maker from shipping carton. Ice maker
is shipped with arm down. This is correct for ice
production. Do not force arm down or up, past stop
positions.
Loading ...
Loading ...
Loading ...