Loading ...
Loading ...
Contents Safety Instructions
Introduction ............................................................... 3
Safety Instructions .................................................... 3
Materials Required .................................................. 3
Parts ....................................................................... 4
Procedure ............................................................... 6
Operating Instructions ............................................... 9
Before Calling for Service ......................................... 9
Warranty ................................................................. 10
Introduction
Recognize this symbol as a safety
precaution
Caution
To avoid personal injury or property damage,
observe all safety instructions.
WARNING
To avoid electrical shock which can cause
severe personal injury or death, disconnect
power to refrigerator before installing kit.
After installing kit, connect power.
Caution
To avoid property damage, observe the
following:
• Confirm water pressure to water valve is
at least 20 pounds per square inch.
• Start nuts by hand to avoid cross
threading. Finish tightening nuts using an
adjustable wrench. Do not overtighten.
• Check carefully for water leaks prior to
returning refrigerator to normal location
and 24 hours after connection.
Read entire manual before installing kit. All necessary
tools and materials must be available prior to
installation. Verify all listed parts are included in kit. If
parts are missing, contact source from whom kit was
purchased.
Mechanical experience is required to install kit.
Depending on installer's knowledge and skill,
installation can take from 3 to 6 hours.
If unable to solve a problem during installation,
contact an authorized Amana ®technician. Locate a
Factory Service Center or independent authorized
Amana ®technician by calling 1-800-628-5782 inside
U.S.A. and 1-319-622-5511 outside U.S.A. Service
is at owner's expense.
Materials Required
Important
• Before connecting ice maker, contact a plumber to
connect copper tubing to household plumbing in
compliance with local codes and ordinances.
• Amana Refrigeration, Inc. recommends using a
saddle valve. Do not use self-piercing valve. Amana
Refrigeration, Inc. is not responsible for property
damage due to improper installation or water
connection.
1/4" (6 mm) flexible copper tubing*.
*Length of copper tubing must reach from water supply
connection plus an additional 8' (2 m) for service loop
behind refrigerator. Tubing should be soft instead of
rigid and ends should be free of burrs.
Loading ...
Loading ...
Loading ...