Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTIONS
To maximize operating efficiency, do
not run the engine for longer than 1
minute at a time at full throttle.
OPERATING POSITION
ALWAYS USE:
Hearing
Protection _( Eye Protection
Long
Pants
Heavy
Shoes
Cut from your left to your right,
,_WARNING: Always wear eye
protection and hearing protection. Never
lean over the trimmer head. Rocks or
debris can ricochet or be thrown into
eyes and face and cause blindness or
other serious injury.
When operating unit, stand as shown
and check for the following:
• Wear eye protection, hearing protec-
tion and heavy clothing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Hold unit so that engine is below
waist level.
• Cut only from your left to your right to
ensure debris is thrown away from
you. Without bending over, keep line
near and parallel to the ground and
not crowded into material being cut.
Do not run the engine at a higher speed
than necessary. The cutting line will cut
efficiently when the engine is run at less
than full throttle. At lower speeds, there
is less engine noise and vibration.
Always release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
HOW TO STOP YOUR UNIT
• Release the throttle trigger.
• Move the ON/OFF switch to the OFF
position.
TRIMMER LINE ADVANCE
The trimmer line will advance approxi-
mately 2 inches (5 cm) each time the
bottom of the trimmer head is tapped
on the ground with the engine running
at full throttle.
The most efficient line length is the
maximum length allowed by the line
limiter. Always keep the shield in place
when the tool is being operated.
To advance line:
• Operate the engine at full throttle.
• Hold the trimmer head parallel to
and above the grassy area.
• Tap the bottom of the trimmer head
lightly on the ground one time. Ap-
proximately 2 inches (5 cm) of line
will be advanced with each tap.
Always tap the trimmer head on a
grassy area. Tapping on surfaces such
as concrete or asphalt can cause ex-
cessive wear to the trimmer head.if the
line is worn down to 2 inches (5 cm) or
less, more than one tap will be required
to obtain the most efficient line length.
_,WARNING: Use only 0.095 inch
(2.4 ram) diameter line. Other sizes of
line will not advance properly and will
result in improper cutting head func-
tion or can cause serious injury. Do
not use other materials such as wire,
string, rope, etc. Wire can break off
during cutting and become a danger-
ous missile that can cause serious in-
jury.
CUTTING METHODS
A_,WARNING: Use minimum
speed and do not crowd the line when
cutting around hard objects (rock,
gravel, fence posts, etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of line does Line crowded into
the cutting,
Right W_'ong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences.
7
Loading ...
Loading ...
Loading ...