Loading ...
Loading ...
Loading ...
,_ WARNING: Do not allow familiarity with your drill-
driver to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
BATTERY PACK
The battery pack for your tool has been shipped in a low
charge condition to prevent possible problems. Therefore,
you should charge it until light on front of charger changes
from red to green.
Note: Batteries will not reach full charge the first time they
are charged. Allow several cycles (drilling followed by
recharging) for them to become fully charged.
CHARGING BATTERY PACK
See Figure 4.
• Charge battery pack only with the charger provided.
• Make sure power supply is normal household
voltage, 120 volts, 60 Hz, AC only.
• Connect charger to power supply.
• Place battery pack in charger aligning raised rib on
battery pack with groove in charger. See Figure 2.
• Press down on battery pack to be sure contacts on
battery pack engage properly with contacts in charger.
• Normally, the red LED on charger wilt come on. This
indicates charger is in fast charging mode.
• Red LED should remain on for approximately 1 hour
then the green LED will come on. Green LED on
indicates battery pack is fully charged and charger is in
trickle charge mode. Note: Green LED wilt remain on
until battery pack is removed from charger or charger
is disconnected from power supply.
BATTERYPACK
SHOWNINCHARGER
• If both yellow and green LED come on, this indicates a
deeply discharged or defective battery pack.
Allow battery pack to remain in charger for 15 to 30
minutes. When battery pack reaches normal voltage
range, red LED should come on.
If red LED does not come on after 30 minutes, this
indicates a defective battery pack and should be
replaced.
• After normal usage, a minimum of 1 hour of charging
time is required to fully recharge battery pack.
• The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
• Do not place charger and battery pack in an area of
extreme heat or cold. It will work best at normal room
temperature.
Note: Charger and battery pack should be placed in a
location where the temperature is more than 50°F but
less than 100°F.
• When batteries become fully charged, unplug charger
from power supply and remove the battery pack.
4-1/2in,
CHARGER
REDLEDONINDICATES
Fig. 5
GREENLEDONAFTERFASTCHARGING
INDICATESFULLYCHARGEDBATTERY
PACKANDINTRICKLECHARGEMODE.
YELLOWANDGREENLEDSONINDICATESDEEPLY
DISCHARGEDORDEFECTIVEBATTERYPACK.
Fig. 4
11
Loading ...
Loading ...
Loading ...