Loading ...
Loading ...
Loading ...
PROBLEM
Tool runs slowly.
Automatic line feed does not
feed more line.
SOLUTION
Check that the spool housing
can rotate freely. Carefully clean
it if necessary.
• Check that the cutting line
does not protrude more than
approximately 5-3/8 inches
(136mm) from the spool. If it
does, cut it off so that it just
reaches the line trimmingblade.
• If the toot still runs stov_ty, stop
using the tool and take it to a
serwce center.
More line is fed when the line
shortens to approximately 3
inches (76.2mm). To determine if
the line is not feeding, let line
wear past this point.
• Keep the tabs depressed and
remove the spool from the spool
housing in the trimmer head.
• Ensure that the line is not
crisscrossed on the spool as
detailed in figure O. If it is,
unwind the cutting line, then
wind it back on the spool neatly
so that the lines do not cross.
• Inspect tracks at the bottom of
spool for damage. If damaged,
replace spool.
•Read the code on the back of
spool. Ifit reads "PA66"call
customer service for a replacement.
Ifit reads "ABS" this is not the issue.
11
PROBLEM
Automatic line feed does not
feed more line.
Overfeeding
SOLUTION
• Pull the cutting line until it
protrudes approximately 5-3/8
inches (136mm) from the spool.
If insufficient cutting line is left
on the spool, install a new spool
of cutting line.
• Align the tabs on the spool cap
with the cut outs in the housing.
• Push the spoolcap ontothe housing
untilit snapssecurely intoplace.
• If the cutting line protrudes
beyond the trimming blade, cut
it off so that it just reaches the
blade. If the automatic line
feed still does not work or the
spool is jammed, try the
following suggestions:
• Carefully clean the spool
and housEng.
• Remove the spool and check if
the lever in the spool housing can
move freely.
• Remove the spool and
unwind the cutting line, then
wind it on neatly again.
Replace the spootinto
the housing.
• Ensure you are cutting with
the tip of the line (5.25 inches
U 33.4mm) from the spool).
se the edge guide if needed to
ensure proper space is
maintained.
• Ensure you are not
exceeding a 10 ° angle as
shown infigure J1.
Loading ...
Loading ...
Loading ...