Loading ...
Loading ...
Loading ...
4
Installation Instructions
Installing the Cooktop
Note: Before proceeding with installation read the work instructions carefully.
1. Place a towel or cloth on the work surface. Place the cooktop face down on the
protected surface.
2. Apply the strip seal, supplied with the hob, which is for sealing it onto the work
surface. Do not use silicone. Apply the seal to the edge of the bottom of the
cooktop, leaving about 3mm from the edge of the glass. Apply the seal all around
the circumference. Cut off any excess and bring the two ends of the seal together
so they match.
3. Fix the brackets (4 or 5 pcs) on the front side and rear side by screw. Put the
cooktop in the cut-out and make centre it. Ensure that the front edge of the
cooktop is parallel to the side edge of the work surface.
• IMPORTANT: You must observe the ventilation requirements shown in the figure below.
• IMPORTANT: There are ventilation holes around the outside of the cooktop. YOU MUST ensure that these
holes are not blocked by the benchtop when you put the cooktop into position (see figure below).
• IMPORTANT: Do not use a silicon sealant to seal the appliance against the benchtop. This will make it
difficult to remove the cooktop from the benchtop in the future, particularly if it needs to be serviced.
Loading ...
Loading ...
Loading ...