Loading ...
Loading ...
Loading ...
TO ADJUST BRAKE
Your tractor is equipped with an adjust-
able brake system which is mounted on
the side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in
highest gear on a level dry concrete or
paved surface, then brake must be
adjusted.
1. Depress clutch/brake pedal and
engage parking brake.
2. Measure distance between brake
operating arm and nut "A" on brake
rod.
3. If distance is other than 1-3/4", loosen
jam nut and turn nut "A" until distance
becomes 1-3/4". Retighten jam nut
against nut =A".
4. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest
gear, further maintenance is neces-
sary. Contact a Sears or other
qualified service center.
WITH PARKING BRAKE"ENGAGED"
Nut
Operating Arm
Do not touch this nut. If further brake
adjustment is necessary, contact a Sears or
other qualified service center.
rO REPLACE MOTION DRIVE BELT
_ark the tractor on level surface. Engage
_arking brake. For assistance, there is a
_elt installation guide decal on bottom
_ide of left footrest.
3ELT REMOVAL-
=. Remove mower (See "TO REMOVE
MOWER" in this section of manual).
_IOTE: Observe entire motion drive belt
md position of all belt guides and
,eepers.
.L Disconnect clutch wire harness.
3. Remove clutch Iocator.
L Remove belt from stationary idler and
clutching idler.
5. Remove belt downward from engine
pulley and around electric Clutch.
6. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmissioninput pulley and over
coolingfan blades.
7. Remove belt from center span keeper
and pull belt away from tractor.
BELT INSTALLATION -
1. Carefully work new belt down around
transmission cooling fan and onto the
input pulley.
2. Slide belt into the center span keeper.
3. Pull belt toward front of tractor and roll
belt around electric clutch and onto
engine pulley.
4. Install belt through stationary idler and
clutching idler.
5. Reinstall clutch Iocator and tighten nut
securely.
6. Reconnect clutch harness.
7. Make sure belt is in all pulley grooves
and inside all belt guides and keep-
ers.
8. Install mower (See "TO INSTALL
MOWER" in this section of manual).
Electric-- ,,
Clutch _ ,..Clutcn
Ij_:_/_ Locator
Clutching_ I _
Idler II Y I _ _ I._
Stationary_l t _ li_
Center Spar_ J_
Keeper I[S': _. Clutch
_1_/i-_ : _ Wire
Transmissior_ I " _ /'_ Harness
Input Pulley _@
TRANSMISSION REMOVAL/REPLACE-
MENT
Should your transmission require
removal for service or replacement, it
should be purged after reinstallation and
before operating the tractor. See "PURGE
TRANSMISSION" in the Operation
section of this manual.
TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not
horizontal (left to right) when wheels are
positioned straight forward, remove
steering wheel and reassemble with
crossbars horizontal. Tighten securely.
24
Loading ...
Loading ...
Loading ...