Loading ...
Loading ...
Loading ...
TO REMOVE BELT GUARD
NOTE: For ease of removal, =remove hair-
pin clip and clevis pin from left wheel. Pull
wheel out from tiller about I inch.
• Remove two (2) screws and washers
from side of belt guard.
• Remove hex nut and washer from bot-
tom of belt guard (located behind
wheel).
• Pull belt guard out and away from unit.
• Replace belt guard by reversing above
procedure.
Belt Guard Screw and Washer/_
/ _ Rex Nut
__/J// and
/ Washer
_---__../ _,_ (L.o_.ted
V_._'_F_I___-_._: _p_ Behind
Screw and'_ _ I
Washer Hairpin Clip and
Clevis Pin
TO REPLACE GROUND DRIVE
BELT
• Remove belt guard as described in "TO
REMOVE BELT GUARD".
• Loosen belt guides "A"and =B"and
also stud "C".
• Remove old belt by slipping off engine
pulley first then remove from transmis-
sion pulley.
• Place new belt in groove of transmis-
sion pulley and into engine pulley. BELT
MUST BE IN GROOVE ON TOP OF
IDLER PULLEY. NOTE POSITION OF
BELT TO GUIDES.
• "tqghten belt guides "A" and "B" and stud
=C".
• Check belt adjustment as descdbed
below.
• Replace belt guard.
• Reposition wheel and replace clevis pin
and hairpin clip.
GROUND DRIVE BELT ADJUST-
MENT
For proper belt tension, the extension
spring should have about 5/8 inch stretch
when drive control bar is in =ENGAGED"
position. This tension can be attained as
follows:
• Loosen cable clip screw secudng the
drive control cable.
• Slide cable forward for less tension and
rearward for more tension until about 5/8
inch stretch is obtained while the ddve
control bar is engaged.
• '_ghten cable clip screw securely.
Engin ; Pulley
Belt Guide "A"
Cable _Screw
Ddve Control Cable
Stud =C"
Idler Pulley
Exten_on Spdng"
Transmission Pulley
16
Loading ...
Loading ...
Loading ...