Loading ...
Loading ...
Loading ...
EN -12
INSTALLATION AND ASSEMBLY INSTRUCTIONS
The suction of the downdrafts, regarding the traditional hoods, is penalized in the suction of the cooking vapors of the
front pots. For this reason the use of a panoramic glass ceramic top is suggested.
The hood can be combined with gas hob with maximum total power of back heaters equal to 4.7 Kw.
Warning: We decline all responsibility for damages to hoods with gas installations with higher powers.
Once the installation is complete, the electrical components (cables, connectors, motor and control box) will no
longer be accessible to the user. To allow access to those parts place a removable panel secured with screws.
The downdraft can be used for both filtering and suction. When the filtering function is operating, with air recycle,
carbon filters must be used. When the downdraft is used in the filtering function, there must be a suitable section for
spillage of the air suction on the base of the kitchen.
When the suction function is operating, exhausting the filtered air on the outside, a suitable compensation system
must be used according to current standards in force. The diameter of the fume exhaust pipe must be the same or
greater than the diameter of the downdraft pipe union.
There must be sufficient ventilation in the room where the downdraft is installed, to allow the simultaneous use of
other appliances that use gas or other fuels.
Make a hole in the downdraft approximately 50mm from
the work top hole.
For the dimensions of the hole, see drawing here below.
To install the hood, adjust the height of the leg support "S" so you can
place the hood under the kitchen top.
Raise the hood with the legs up until the structure of the hood leans
on the kitchen top.
or in the same material used
for the kitchen tops (MAX 7Kg)
Loading ...
Loading ...
Loading ...