Loading ...
Loading ...
ASSEMBLY INSTRUCTIONS (continued)
For eave mounted only:
Swing the sensor head towards the mounting surface.
Rotate the sensor head clockwise 180˚ so the controls face down.
Turn off the power at fuse or circuit box.
Installation Steps
1. Install the mounting strap (BB) to
the outlet box with the stamped
word “FRONT” facing away from
the outlet box, using two mounting
screws (AA) that best fit the outlet
box. (Choose one matching pair of
suitable mounting screws from the
3 pairs provided)
2. Connect the house grounding wire
and the fixture grounding wire
(green / yellow) using the wire
connector (CC).
Connect the fixture black wire to
the house black wire and the fixture
white wire to the house white wire
using wire connector (CC) provided.
Carefully tuck the wires back into the outlet box.
Adjusting the Sensor Head:
1. a: Aim sensor head (C) toward desired detection area, maintaining a 5° - 40°
downward angle to allow moisture to drain.
Note: Make sure sensor head is positioned with control knob facing towards the
ground.
b: You can rotate the sensor head up and down to change the coverage area.
(See Fig.1)
2. Note: Range set too high may increase false triggering. (See Fig.2, Fig.3)
3. Attach the backplate of the light
fixture (A) to the mounting strap
(BB) by secure it with the fixture
mounting screw (EE). Push the
decorative cover (DD) firmly into
the fixture mounting screw hole
on the light fixture (A).
Sensor Adjustment Lower For Short Coverage
Sensor Adjustment Higher For Long Coverage
Fig. 2 Fig. 3
1
BB
AA
Outlet Box
3
CC
Page 3 of 8
211019
Backplate
Controls
4
DD
A
EE
BB
5
A
Controls
Controls
2. Thread the fixture wires through
gasket (FF), and then attach the
gasket (FF) into backplate of the
light fixture (A).
2
A
FF
5. Use silicone caulking compound (not included), caulk completely around where the backplate
of the light fixture (A) meets the wall surface.
CAUTION: Be sure to caulk completely where the backplate meets the wall surface to
prevent water from seeping into the light fixture (A) and outlet box.
Fig. 1
C
Loading ...
Loading ...
Loading ...