Loading ...
Loading ...
Loading ...
OPERATION
HOW TO USE YOUR CHAIN SAW
STOPPING YOUR ENGINE
, Move on/stop switch to the "STOP" position,
o If engine does not stop, pull blue choke knob out fully.
CHAIN OILER (Fig. 7)
= The chain oiler provides continuouslubrication to the
chain and guide bar Be sure to fill the bar oii tank
when you fill the fuel tank (Capacity = 6,8 fl oz°),
- Your chain saw wilt consume approximately one tank
of bar oil for each tank of fuel used,,
° Your chain oiler is automatic and requires no adjust-
mont.
Bar _
Oil Fill
Cap
Front Handle
"_.,_., Fuel Mix Cap
Figure 7
THROTTLE CONTROL GROUP (Fig. 8)
THROTTLE LOCKOUT
o The throttle lockout disables the throttle trigger.
o The throttle lockout prevents unintentional actuation of
the throttle trigger°
THROTTLE TRIGGER
o The throttle trigger atlows for variable control of
engine speed.
= The throttle trigger is actuated by the index finger on
your right hand
FAST IDLE LOCK
= The fast idle lock allows for faster engine speeds dur-
ing starting°
, The fast idle lock is engaged by the following steps:
- Grasp the rear handle and depress the throttle lock-
out,
- Squeeze the throttle trigger fully and hold,
- Depress the fast idle lock with your thumb and hold,
- Release your grip on the throttle trigger and throttle
lock while continuing to hold the fast idle lock,,
NOTE: Verify the throttle trigger stays in the advanced
position,
tJ[. t'_ Fast Idle Throttle
Lookout
..... 'q_ _ Trigge r
Figure 8
CHOKE (Fig. 9)
° The choke provides additional fuel when starting a
cold engine,
o The choke isactuated by pulling the blue choke knob,
, The choke has two positions: partial and full,
Primer_
Bulb
STOP
Choke Positions
t
Off Partial Full
Figure 9
-8 _
Loading ...
Loading ...
Loading ...