Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove the exterior and interior packing.
Before connecting the wine cooler to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
This appliance is especially designed for the storage of wine; do not use it for
other purposes.
Installation of Your Wine Cooler
This appliance is designed for free standing or built-in (fully recessed) installation.
If free standing, the unit should have at least 4” of clearance at both sides, at the
top and at the back to allow for adequate ventilation.
If the appliance is to be built-in, leave at least 3/16” at both sides, 1/16” at the top
and 2” at the rear. Be sure that airflow under the appliance is not blocked. The
diagram below shows the correct dimensions for under-counter installation:
Place your wine cooler on a floor that is strong enough to support it when it is fully
loaded. To level your wine cooler, adjust the leveling legs at the bottom of the unit.
Locate the wine cooler away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the exterior surface and heat
sources may increase electrical consumption. Extremely cold or warm ambient
23.62”
23.43”
23.62”
(min)
33.27”
3.54”
33.86
”
(min)
Loading ...
Loading ...
Loading ...