Frigidaire LESR26EFE5 refrigerator

User Manual - Page 5

For LESR26EFE5.

PDF File Manual, 26 pages, Download pdf file

Loading ...
Loading ...
Loading ...
To Connect Water Supply Line To Ice Maker Inlet Valve
1. Disconnect refrigerator from electric power source.
2. Place end of water supply line into sink or bucket. Turn ON
water supply and flush suppty Iine until water is clear. Turn
OFF water supply at shutoff valve.
3. Unscrew pIastic cap from water valve inlet and discard
cap.
4. Slide brass compression nut, then ferrule (sleeve) onto
water supply line, as shown.
5. Push water supply Iine into water valve inIet as far as it will
go inch). SIide ferruIe (sleeve) into valve inlet and
finger tighten compression nut onto valve. Tighten another
half turn with a wrench; DO NOT over tighten.
6. With steel clamp and screw, secure water supply Iine to
rear panel of refrigerator as shown.
7. Coil excess water suppIy line (about 2Y2 turns) behind
refrigerator as shown and arrange coils so they do not
vibrate or wear against any other surface.
8. Turn ON water suppIy at shutoff vaIve and tighten any
connections that leak.
9. Reconnect refrigerator to electrical power source.
10. To turn ice maker on, Iower wire signal arm (side
mounted) or set the ice maker's On/Off power switch to the
"t" position. (rear mounted)
Before installing The Water Supply Line, You Will Need:
,, Basic Tools: adjustable wrench, flat-blade screwdriver,
and Phillips T_'_screwdriver
,, Access to a household cold water line with water pressure
between 30 and 100 psi.
,, A water supply line made of ¼ inch (6.4 ram) OD, copper
tubing. To determine the length of copper tubing needed,
you wilI need to measure the distance from the ice maker
inlet valve at the back of the refrigerator to your cold water
pipe. Then add approximately 7 feet (2.1 meters), so the
refrigerator can be moved out for cleaning (as shown).
,, A shutoff valve to connect the water supply Iine to your
household water system. DO NOT use a self-piercing type
shutoff valve.
,, A compression nut and ferrule (sleeve) for connecting the
water supply line to the ice maker inlet valve.
to Ice Maker
Fill Tuba
(Sleeve'_
_ater line
from r _usehold water supply
ndude enougn _aalng _ loop to allow
moving refrigerator out for cUaarling
Loading ...
Loading ...
Loading ...