Loading ...
Loading ...
Loading ...
MOUNTING THE MITER SAW
_, WARNING
To reduce the risk of injury from unexpected
saw movement, place the saw in the desired
location either on a workbench or other
suitable machine stand.
The base of the saw has four mounting holes
through which suitable bolts can be placed to
secure the miter saw. If the saw is to be used
in one location, permanently fasten it to the
workbench using appropriate fasteners (not
supplied). Use locking washers and nuts on
the underside of the workbench.
(Fig. G)
(Fig. G)
I I
I I
I I
I I
I I
I I
I I
1. Tighten the miter and bevel locks.
See OPERATION section.
2. To avoid injury from flying debris, position
the saw so that other people or bystanders
cannot stand too close (or behind) it.
5. Bolt or clamp the saw securely to its
support stand or workbench.
For portable use:
1. Mount the saw on a 3_ in. thick piece of
plywood using appropriate fasteners (not
supplied).
2. It may be necessary to countersink the
washers, nuts etc. to the underside of the
plywood mounting board to avoid an uneven
work surface.
3. Use 'C'- clamps to attach the mounting
board to the work surface. (Fig. H)
(Fig. H)
ADJUSTMENT INSTRUCTIONS
1_. WARNING j
To avoid injury from electric shock or from
an accidental start, make sure the switch
is in the OFF position and the plug is not
connected a power source outlet.
3. Locate the saw on a firm, level surface
where there is plenty of room for handling
and properly supporting the workpiece.
NOTE: When checking angular alignments
the Cutting Head should be lowered and
locked in the down position with the
latching pin fully located in its socket.
4. Support the saw so the machine table is
Refer to 'Locking the Cutting Head in the
level and the saw does not rock.
down position' page 18
21
Loading ...
Loading ...
Loading ...