Loading ...
Loading ...
Loading ...
TROUBLESHOOTING POMNTS
......................._rJi,lily, ::
PROBLEM
Does not start
Loss of power
, lU nl,nllUl,,
Poor cut - uneven
Excessive vibration
Starter rope hard to pull
Loss of drive
(Self-Propelled Mowing)
..
Grass catcher not filling
(if so equipped)
Hard to push
CAUSE
,,n ,,imlU illi,ml iNUl,ml
I Dirty air filter
2 Out of fuel
3 Stalefuel
4 Water in fuel
CORRECTION
1 Clean/replace air tilter
2 Fitl fuel tank
3 Drain tank and refill with fresh clean fuel,
4 Drain fuel tank and carburetorand refill tank with fresh
gasoline,
5 Spark plug wire isdisconnected
6 Bad spark plug
7 Loose blade or broken blade adapter
8 Control bar in released posiUon
9 Control bar defective
illUmH,, lun ,lUlUl i
1 Rear of lawn mower housing/blade dragging
in heavy grass
2 Cutting too much grass
3 Didy air fiiter
4 Buildup of grass, leaves and trash under mower
5 Too much oitin engine
6 Walking speed too fast
1 Worn, bent or loose blade
2 Wheel heights uneven
3 Low engine speed,
4, Buildup ot grass, leaves, and trash under mower
, n ....................................
1 Worn, benf or loose blade
2 Bent engine crankshaft
Engine flywheel brake is on when control bar is
released
2 Bent engine crankshaft
3 Blade adapter broken
4 Blade dragging in grass
1 Drive wheels nof turning with drive control engaged
2 Belt not driving
1 Cutting height too low
2 Lift on blade worn off
3 Catcher not venting air
4 Low engine speed
1 Grass is too high or wheel height is too low.
2. Rear of lawn mower housing/blade dragging
in grass
3 Grass catcher too ful_
4 Handle height position not right for you
5 Connect wire to plug
6 Replace spark plug
7 Tigh{en btade boil or replace blade adapter,
8 Depress control bar to handle
9 Replace control bar
1 Set in "Higher Cut" position
2. Set in "Higher Cut" position
3 Clean/replace air fitter
4 Clean underside of mower housing
5 Check oil level
6 Cut at slower walking speed
1 Replace blade Tighten blade bolt
2 Set all wheels at same height
3 Set engine speed control in fast posit{on
4 Ctean underside of mower housing
1 Replace blade Tighten blade bolt
2 Contact an authorized ser,,ice center!department
1 Depress control bar io upper handle before
pulling starter rope
2 Contact an authorized service center/department
3 Replace blade adapter
4 Move lawn mower to cut grass or to hard surface
to start engine
1 Adjust or replace drive conlrol cable, if broken,
2 Put belt on pulleys or replace belts if broken
1 Raise cutting height
2 Replace blade
3 Clean grass catcher
4 Set engine speed control in fast position
1 Raise cutting height
2 Raise rear of lawn mower housing one (1)
setting higher
3 Empty grass catcher
4 Adjust handle height to suit
26
Loading ...
Loading ...