Loading ...
Loading ...
Loading ...
CUSTOMER ESPONSIBILiTIES
=,uu,un = = = 11 n mnn,n,H,,,,,n,,u,,, J,,,,ui
ENGINE
LUBRICATION
Use only high quality detergent oil rated with API service
classification SF or SG. Select the oil's SAE viscosity grade
according to your expected operating temperature.
SAE VISCOSITY GRADES
_F "20_ 0 ° 30 _ 32 _ 40 _ 604 80 _ 100"
TEMPERATUREnANGEANTIC_PATEO_O_E .E×TOILCHAN_E
NOTE: Although multi-viscosity oils (5W30, 10W30 etc.)
improve starting in cord weather, these multi-viscosity oils
wilt result in increased oil consumption when used above
32°F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
Change the oil after the first two hours of operation and
every 25 hours thereafter or at least once a year ifthe fawn
mower is not used for 25 hours in one year.
Check the crankcase oil level before starting the engine
and after each five (5) hours of continuous use. Tighten oil
plug securely each time you check the oil level.
TO CHANGE ENGINE OIL (See Fig. 8)
NOTE: Before tipping lawn mower to drain oil, drain fuet
tank by running engine until fuel tank is empty
- Disconnect spark plug wire from spark plug and place
wire where it cannot come in contact with spark plug.
- Remove engine oil cap; lay aside on a clean surface.
Tip tawn mower on its side and drain oil into a suitable
container. Rock lawn mower back and forth to remove
any oil trapped inside of engine.
, Wipe off any spilled oit on lawn mower and on side of
engine.
, Fill engine with oil, Fili only to the "FULL" line on the
dipstick_ DO NOT OVER FILL..
, Replace engine oil cap
, Reconnect spark plug wire to spark plugo
CONTAINER
FIG. 8
AIR FILTER
Your engine will not run properly and may be damaged by
using a dirty air filter.
Replace the air filter every year, more often ifyou mow in
very dusty, dirty conditions.
TO CLEAN AIR FILTER (See Fig. 9)
o Loosen screw and tilt cover to remove
, Carefully remove cartridge.
o Clean by gently tapping on a fiat surface Ifvery dirty, 11
replace cartridge.
CAUTION: Petroleum solvents, such
as kerosene, are not to be used to clean
cartridge. They may cause deteriora-
tion of the cartridge. Do not oil car-
tridge. Do not use pressurized air to
clean or dry cartridge.
,' ,= ........................ H=,,,u
, Install cartridge, then replace cover making sure the
tabs are aligned with the slots inthe back plate Fasten
screw securely
LiP --_ BACK
PLATE
TABS
CARTRIDGE
COVER
FIG. 9
MUFFLER
inspect and replace corroded muffler as it could create a
fire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to make your engine
start easierand run better Set spark plug gap at ..030 inch
CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP
MOWER HOUSING FREE OF BUILT-UP GRASS AND
TRASH CLEAN THE UNDERSIDE OF YOUR MOWER
AFTER EACH USE,
CAUTION: Disconnect spark plug wire
,_/_ from spark plug and place wire where it
cannot come in contact with the spark
= Turn lawn mower on its side Make sure air filter and
carburetor are up Clean the underside of your lawn
mower by scraping to remove build-up of grass and
trash.
o Clean engine often to keep trash from accumulating. A
clogged engine runs hotter and shortens engine life
, Keep finished surfaces and wheels free of all gasoline,
oil,etc
o We do not recommend using a garden hose to dean
lawn mower unless the electrical system, muffler, air'
filter and carburetor are covered to keep water ouL
Water in engine can result in shortened engine life,.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape
underside of cover with putty knife or similar tool to remove
any build-up of trash or grass on underside of drive cover,
Loading ...
Loading ...
Loading ...