Loading ...
Loading ...
Loading ...
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher fills with water covering the filter area. Water is
then pumped through the spray arms. Soil particles go through and across the filter and down the
drain as the water is pumped out. This series of steps are repeated as needed. The number of
water fills vary with the cycle being used.
Nozzle or Spray Arm
Rack
Serial LaDe]
Right)
Middle Spray Arm
Lower Spray Arm
Overfill
Deter(
Silverware Basket
Glass Trap
Heating Element
Aid
Features may vary according to model
Operating Instructions
Getting Started
1. Load Dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher Dispenser
& Detergents).
3. Add Rinse Aid, if needed (See Rinse Aid).
4. Close door to latch.
5. Select desired CYCLE (See Cycle Chart).
The indicator light above the pad will glow
when selected.
6. Select desired OPTION (See Energy
Options). The indicator light above the pad
will glow when selected.
7, Run hot water faucet nearest dishwasher
until water is hot, Turn water off.
8. To start, press START/CANCEL pad.
Wash Cycle Selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty
food soils. An automatic sensor will check
the incoming water temperature and, if it is
not hot enough, the cycle will be lengthend
for automatic water heating in the main wash
and final rinse of all cycles. This happens
even when HI-TEMP WASH option has not be
selected. When HI-TEMP WASH is selected,
an even higher temperature will be reached to
handle heavier soil loads.
Loading ...
Loading ...
Loading ...