Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
This appliance is meant for free-standing installation; it should not be built-in.
Do not put heavy items on top of the unit.
Do not store or install the appliance outdoors.
This appliance is designed for storing and cooling beverages and drinks.
Do not use it to store perishable food, medicine or other medical products.
Moving and Installing Your Appliance
When transporting, keep the unit vertical as much as possible. The angle between the vertical and the
side of the unit should never exceed 40° since this could affect the compressor and result in abnormal
operation.
After unpacking the unit, remove the packing materials and place the unit on a level and sturdy floor
near a power socket.
Leave at least 4" of space between the back of the unit and the wall for ventilation. Leave space
enough to allow the door to swing open 160°.
Keep the unit away from heat sources and avoid direct sunlight.
Never place the unit in a location with high humidity or where water can reach it.
Electrical Connection
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
Never ground the unit through a gas pipe, tap water pipe or the grounded wire of a single-phase
power supply.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into an exclusive, properly grounded wall outlet which has a
voltage rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug
the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
6
Loading ...
Loading ...
Loading ...