Loading ...
Loading ...
Loading ...
ASSEMBLY
SEAT PAN/I
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
• Remove adjustment knob and fiat washer securing seat
to cardboard packing and set aside for assembly ofseat
to tractor.
• Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
• Place seat on seat pan so head of shoulder bolt is
positioned over large slotted hole in pan.
• Push down on seat to engage shoulder bolt in slot and
pull seat towards rear of tractor.
• Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten.
• Lower seat intooperating position and sit on seat.
• Slide seat until a comfortable position isreached which
allows you to press clutch/brake pedal all the way down.
• Get off seat without moving itsadjusted position.
• Raise seat and tighten adjustment knob securely.
SHOULDER
BOLT
FLAT WASHER
ADJUSTMENT
KNOB
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Operation
section, page 10, for location and function of
controls)
• Press lift lever plunger and raise attachment lift lever to
itshighest position.
• Release parking brake by depressing clutch/brake pedal.
• Place freewheel control in freewheeling position to
disengage transmission (See "TO TRANSPORT" inthe
Operation section of this manual).
• Roll tractor forward off skid.
• Remove banding holding deflector shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera-
tion section, page 10, for location and func-
tion of controls)
_kWARNING: Before starting, read, understand and follow
all instructionsin the Operation section of this manual. Be
sure tractor is ina well-ventilated area. Be sure the area in
front of tractor isclear of other people and objects.
• Be sure all the above assembly steps have been
completed.
• Check engine oil level and fill fuel tank with gasoline.
• Place freewheel control in"transmission engaged" po-
sition.
• Sit on seat inoperating position, depress clutch/brake
pedal and set the parking brake.
• Place motion control lever in neutral (N) position.
• Press lift lever plunger and raise attachment lift lever to
its highest position.
• Startthe engine. After engine has started, move throttle
control to idleposition.
• Release parking brake.
• Slowly move the motion control lever forward and slowly
drive tractor off skid.
• Apply brake to stop tractor, set parking brake and place
motion control lever inneutral position.
• Turn ignition key to "OFF" position.
Continue with the instructionsthat follow.
FIG. 3
7
Loading ...
Loading ...
Loading ...