Loading ...
Loading ...
Loading ...
_E!ectricaJ_q_%nnec_jon__9_ _ops....................
If your And you Go to
home has: will be Section:
connecting
to:
4-wirereceptacle A UL listed 4-wire
NEMAType 14-30R 120/240volt connection:
minimum,30
amp., dryer Power
powersupply Supply
Cord
cord*
4-wire direct A fused 4-wire
disconnect or connection:
circuit breaker
box* Direct Wire
3-wire receptacle A UL listed, 3-wire
(NEMAtype 10-30R) 120/240 volt connection:
minimum, 30
amp., dryer Power
Supply
power supply Cord
cord*
3-wire direct A fused 3-wire
disconnect or connection:
circuit breaker
box* Direct Wire
*If local codes do not permit the
connection of a frame-grounding
conductor to the neutral wire, go to
"Optional 3-wire connection" section.
4-wire connection: Power Supply Cord
IMPORTANT: A 4-wire connection is
required for mobile homes and where
local codes do not permit the use of 3-wire
connections.
2
3 4
6
5 7
1.4-wire receptacle (NEMA type 14_30R)
2. 4-prong plug
3. Ground prong
4. Neutral prong
5. Spade terminals with upturned ends
6. 3/_in. (1.9 cm) UL approved strain relief
7. Ring terminals
1. Remove center terminal block screw.
2. Remove appliance ground wire (green
with yellow stripes) from external
ground connector screw. Fasten it
under center, silver colored terminal
block screw.
1 2
0
3
1 External ground connector - Dotted
line shows position of NEUTRAL
ground wire before being moved to
center terminal block screw
2 Center silver-colored terminal block
screw
& Green/yellow wire of harness
3. Connect ground wire (green or bare)
of power supply cord to extemal
ground conductor screw. Tighten
screw.
4. Connect neutral wire (white or center
wire) of power supply cord under cen-
ter screw of the terminal block.
4 5
1.3j_in. (1.9 cm), ULqisted strain relief
2 Green wire of power supply cord or
bare copper wire
3. External ground connector
4. Center silver-colored terminal block
screw
5. Neutral wire (white)
6. Neutral grounding wire (green/yellow)
5. Connect the other wires to outer ter-
minal block screws. Tighten screws.
6. Tighten strain relief screws.
7. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with hold-down screw.
11
Loading ...
Loading ...
Loading ...