Loading ...
Loading ...
Loading ...
SOAP
OR
2a. Fill soap tank with approved detergent.
Page 13 REV 2 - 01/03/2022MS61220/MS61221- ENGLISH
1. Attach the open end of the soap hose to the barbed
tting o the pump.
2. Place the ltered end of the soap hose into container
of soap.
USING CHEMICALS
Pressure washing with volatile, ammable, or corrosive liquids could cause pressure
washer damage, re, or explosion resulting in severe injury and/or death. To avoid these
hazards, use only approved soaps and chemicals, do not attempt to pressure wash with
volatile, ammable, or corrosive liquids, and NEVER use bleach.
VOLATILE LIQUIDS
3. Insert the black nozzle into the spray wand per the
Nozzle Installation section of this manual. NOTE:
Soaps will not siphon if the black soap nozzle is not
installed on the spray wand.
4. After using soap, place the ltered end of the soap hose into a container of clean
water and run pressure washer drawing clean water through the hose and pump
until the system is thoroughly rinsed. If soap or other chemicals remain in the pump,
the pump could be damaged. Pump damage from soap or chemical residue is not
covered under warranty.
Loading ...
Loading ...
Loading ...