Hotpoint UIF 9.3F LB Hood

User Manual - Page 23

For UIF 9.3F LB X.

PDF File Manual, 112 pages, Read Online | Download pdf file

UIF 9.3F LB X photo
Loading ...
Loading ...
Loading ...
22
CAUTION!
If the hood is supplied with active charcoal filter, then it must be removed.
Filter version
The aspirated air will be degreased and deodorised before being fed back into the room.
In order to use the hood in this version, you have to install a system of additional filtering based on activated charcoal.
CONTROLS
The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights.
T1. Button ON/OFF suction motor
T2. Selection button operating suction speed (power)
Note: The intensive suction speed (power) (LED L3 flashing) lasts for approximately 5 minutes, then the medium suction speed
(power) is automatically set (LED L2 on)
T3. Button ON/OFF lighting
T4. Selection button ‘silent’ suction speed (power)
L1. LED medium suction speed (power)
L2. LED high suction speed (power)
L3 LED intensive suction speed (power) - timed (5 min.).
L4 LED filter saturation:
flashing: carry out maintenance of the charcoal filter;
on: carry out maintenance of grease filters.
L5 LED low (silent) suction speed (power)
L1+L2+L3 flashing in sequence: automatic operation at high temperature (see related section)
Reset filter saturation
After carrying out filter maintenance, press and hold button T1, LED L4 switches off.
Activation of the LED for charcoal filter saturation
The LED for charcoal filter saturation is normally disabled. To activate it, proceed as follows:
With the hood off, press and hold for a long time and simultaneously T1 and T4: L1 flashes first then L2 as well, to indicate
successful activation.
Disabling the LED for charcoal filter saturation: repeat the above operation, L1 and L2 start flashing first, then only L1, to
indicate successful disabling.
Automatic operation at high temperature
The hood is fitted with a sensor that detects the temperature. When this becomes too high, the sensor automatically activates the
medium suction speed (power). The hood switches off when the temperature detected by the sensor has lowered significantly.
Loading ...
Loading ...
Loading ...