Loading ...
Loading ...
Loading ...
Blaze Outdoor Products Instructional Book
Page | 25
If the main burner cotter pins are removed before installing, the main burners must be double checked for the
correct placement in the grill before operation. When finished ensure that the burners are aligned with the
valve orifice and seated in the bracket slot. This is accomplished by first placing the burner tube shutter
hole securely over the valve orifice and ensuring the male post on the rear of the burner rests in the
corresponding slot in the grill chassis. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges will
be necessary to allow the grill to slide flush against the outer front wall to the outdoor kitchen. Due to differing personal
preferences of the size of the notch out, this is recommended to be done at the point of installation so that the
consumer can dictate their preference.
NOTE: The control panel of this unit is removable for service and must remain accessible. Do not seal around
the control panel preventing removal.
• Slide the appliance into the cut
out and then attach the gas line.
• Be very careful not to kink the gas line when lowering the appliance into the cut out.
• Keep your fingers away from where the appliance will be supported on counter. Your fingers could
become
trapped and serious injury could occur.
• Check to make sure the appliance is level and is supported around the entire outside edge. If the
appliance is
not level or is unstable, use non-combustible shims under the outside lip to stabilize it.
• Perform the leak test procedure as described earlier in this manual.
Loading ...
Loading ...
Loading ...