Loading ...
Important safety instructions
These warnings are in the interests of your safety, ensure that you understand them all before installing or
using this appliance. Please read this user manual carefully and retain for future reference. Your safety is
of paramount importance. If you are unsure about any of the meanings or these warnings contact Palsonic
Customer Service 1300 657 888.
• Before plugging your appliance in check that the
electric supply complies with the rating (voltage,
frequency) of the electric appliance. The rating plate
is usually on the back of the appliance.
• The appliance should always be plugged into an
individual power socket to prevent overloading,
which could cause a possible re hazard from
overheated wires.
• The appliance should be serviced or repaired only
by Palsonic’s Customer Service department or by an
authorised service centre as appointed by Palsonic.
Only genuine spare parts should be used. Under
no circumstances should you attempt to repair the
appliance yourself. Contact Palsonic Customer
Service 1300 657 888.
• Do not use the appliance if the power cord is
damaged. It must be replaced immediately with
a new power cord. Contact Palsonic Customer
Service 1300 657 888. The appliance must be
properly earthed. Palsonic is not responsible for any
accident caused by improper earthing or operation.
• The appliance must be positioned so that the power
plug is accessible.
• Never pull the power cord to disconnect it from the
power socket, grasp the plug and pull it from the
power socket.
• Never drag the appliance by the power cord.
• Keep the power cord away from heated surfaces.
• It is NOT recommended to use the appliance with an
extension cord or power board. Please ensure that it
is plugged directly into the power socket.
• This is an electrical appliance, to avoid injury or
death from electrical shock do not operate the
appliance with wet hands, while standing on a
wet surface or while standing in water. Do not use
outdoors or in wet conditions.
• The rating label for this product located on the
bottom of the unit.
• When electrostatic discharge (ESD) occurs at the
front surface (whether metal or plastic) or near any
part or any button of this unit, or at the USB port
and / or SD-card slots (if they exist on this product),
there may be a possibility that the product may stop
operation and / or shut down immediately. This is
a normal condition and intended to protect the unit
and internal components against damage. In such
a case, please reset the unit (by disconnecting and
reconnecting AC-power source) to revert the unit to
normal operation.
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• ‘Made for iPod’ and ‘Made for iPhone’ mean that an
electronic accessory has been designed to connect
specically to iPod, iPhone, respectively, and has
been certied by the developer to meet Apple
performance standards. Apple is not responsible for
the operation of this device or its compliance with
safety and regulatory standards. Please note that the
use of this accessory with iPod, iPhone may affect
wireless performance.
123
123
Loading ...
Loading ...
Loading ...