Loading ...
Loading ...
Loading ...
I_IL I WARNING: Operate this unit only in a well-ventilated
!
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
_L_____[ ARNING: Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
J
position when pulling the starter rope (Fig. 7).
STARTING INSTRUCTIONS
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON (I) position at all times (Fig. 4).
3. Slowly press and release the primer bulb 10 times (Fig. 5). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Flip the choke lever clockwise until it clicks (Fig. 6).
5. Stand in the starting position (Fig. 7). Hold the handlebar with
one hand. Hold the starter rope with the other hand. Use one
foot to hold the wheels in place.
NOTE: Always tilt the unit back slightly to bring the tines off the
ground when starting the unit (Fig. 6).
6. DO NOT squeeze the throttle control (Fig. 4). Pull the starter rope
with a controlled and steady motion until the unit starts.
NOTE: This unit uses the INCREDI-PULL TM starting system, which
significantly reduces the effort required to start the engine.
7. Idle the engine for 5 to 10 seconds. If the unit stops during this
time, squeeze the throttle control and pull the starter rope in a
controlled and steady motion until the unit starts.
8. Squeeze and hold the throttle control. Allow the engine to warm
up for 30 to 60 seconds.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
IF... the engine does not start, go back to step 3.
IF... the unit is hot and fails to start within 3 pulls of the starter rope,
squeeze the throttle control and pull the starter rope with a
controlled and steady motion until the unit starts.
Stop/Off (O)
Start/On (I)
Fig. 4
Fig. 5
Choke Lever
Throttle Control
On/Off Switch
Primer Bulb
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 4).
Fig. 6
Starting Position
Starter Ro
Throttle
Control
Fig. 7
9
Loading ...
Loading ...
Loading ...