Loading ...
Loading ...
Loading ...
• 4 •
2.10 Do not expose a power pack to re or excessive temperature. Exposure to re or temperature above
265°F (130°C) may cause explosion.
2.11 Have servicing performed by a qualied repair person using only identical replacement parts. This will
ensure that the safety of the product is maintained.
2.12 Attach output cables to a battery and chassis as indicated below. Never allow the output clamps to touch
one another.
3. FEATURES
6
4
3
5
7
8
1
2
1. USB port
2. Rotary switch for USB and jump starter
3. Built-in work light
4. Battery status indicators
5. Battery status button
6. 12V DC power outlet
7. Worklight ON/OFF switch
8. Battery clamps
4. CHARGING THE INTERNAL BATTERY OF THE UNIT
IMPORTANT! CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH USE AND EVERY 30 DAYS,
TO KEEP THE UNIT’S INTERNAL BATTERY FULLY CHARGED AND PROLONG BATTERY LIFE.
4.1 CHECKING THE LEVEL OF THE INTERNAL BATTERY
Press the Battery Status button on the front of the unit. The LED lights will indicate the current charge
level as follows:
RED – less than 20% of full charge; immediately charge the unit.
YELLOW – 20-80% of full charge.
GREEN – more than 80% of full charge.
4.2 CHARGING THE INTERNAL BATTERY
Charge the internal battery for the unit using an extension cord (not included).
NOTE: Use of an improper extension cord could result in a risk of re and electric shock.
1. To charge, ip the AC connector on the back of the unit down and plug in an 18 AWG or larger extension cord.
2. Plug the extension cord into a 120VAC electrical wall outlet.
3. While the unit is charging, the RED LED will be on. Complete charging may take up to 72 hours. When the
RED LED turns off, the unit is ready to use.
4. When the internal battery is fully charged, the charger will automatically go into maintain mode and
maintain the battery at full charge without damaging it. When in maintain mode, the GREEN LED will
pulse, as long as there is an AC cord connected to the charging port.
5. Charge the unit as soon as possible after use.
4.3 CHARGING THE INTERNAL BATTERY WHILE DRIVING
You may also charge the internal battery while driving, using a male-to-male charger cable (part number
94500109 – sold separately).
IMPORTANT: WHEN USING A 12V PORT CHARGING CABLE, DO NOT CHARGE INTERNAL
BATTERY FOR MORE THAN 30 MINUTES OR LEAVE THE BATTERY UNATTENDED. IT COULD
EXPLODE, CAUSING PROPERTY DAMAGE OR PERSONAL INJURY.
1. Make sure the car is running.
2. Insert one end of the accessory cable into the 12V DC power outlet.
3. Insert the other end of the accessory cable into the vehicle’s accessory outlet (lighter socket).
NOTE: The RED LED does not operate during this method of charging. Using this method to charge the
battery overrides the maintain mode and the battery can be overcharged.
Loading ...
Loading ...
Loading ...