Loading ...
Loading ...
Loading ...
– 13 –
10. OPERATION AND USE
10.1 OPERATION & AIR REGULATION
– FIG.5
− To start the sander press down trigger (1), and
release again to slow down/stop the pad.
− To alter the amount of air being fed into the
sander, varying the speed, turn lever (4) during
operation. Adjust accordingly.
If the pad is a non punched type use a suitable tool
to pierce the sheet in the appropriate areas. This
will aid with dust removal, reducing the hazard.
10.2 REPLACING THE BACKING PAD
– FIGS.6 – 7
With the air supply disconnected, lift up the edge of
shroud (6) to access the orbital mechanism.
− Insert spanner (8) and locate onto the flats on
the side of the spindle. Hold the spanner while
rotating the pad (5) to remove.
− When assembling do not over tighten the
backing pad.
Note: Always ensure the spanner has been
removed before restarting the sander as the result
will cause damage or injury.
5
6
FIG.
FIG.
7 FIG.
(1)
(4)
(8)
(6) (5)
Note: Shroud removed to show location.
Loading ...
Loading ...
Loading ...