Loading ...
Loading ...
Loading ...
AS E BLY/PRE-OP ATION
INSTALL DISCHARGE CHUTE / CHUTE ROTATER
HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotater head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotater head over chute bracket. If neces-
sary, rotate chute assembly to align square and pin on un-
derside of chute rotater head with holes in chute bracket.
3. With chute rotater head and chute bracket aligned,
position chute rotater head on pin and threaded stud
of mounting bracket.
4. Install 3/8 washer and Iocknut on threaded stud and
tighten securely.
ALIGN CHUTE ROTATER HEAD
WiTH MOUNTING
BRACKET BEFORE
TiGHTENiNG
LOCKNUT
_3/8 LOCKNUT
_3/8 WASHER
PIN
STUD
CHUTE
BRACKET
ROTATER HEAD
CHUTE MOUNTING
ROTATER HEAD BRACKET
FIG. 7
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1. Install remote cable bracket to discharge chute with
5/1 6-18 carriage bolt, flat washer and 5/16-18 Iocknut
as shown. Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 Iocknut
as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown.
CHUTE
NYLON
WASHER
CABLE !
EYELET
SPRING 1/4-20
SHOULDER
BOLT
HOOK BETWEEN
HEX NUTS
ON CHUTE
ROTATER HEAD
REMOTE
CABLE
BRACKET
5/16-18
CARRIAGE
BO_
FLAT
WASHER
5/16-18
LOCKNUT
FIG. 8
CHUTE DEFLECTOR
CONTROL LEVER
FIG. 9
CHECK TIRE PRESSURE
The tires on your snow thrower were overinflated at the fac-
tory for shipping purposes. Correct and equal tire pressure
is important for best snow throwing performance.
• Reduce tire pressure to 14-17 PSI.
8
Loading ...
Loading ...
Loading ...