Loading ...
Loading ...
Loading ...
6
Caster Installation
1. Remove everything from the cabinet and lay the unit on a clean, dry, and padded sur face
2. Install casters into the holes on the bottom of the unit as show n and tighten with a wrench
3. The two casters equipped with locks should be installed on the front of the unit
4. Once all four casters are attached, return the beer dispenser to an upright position
5. Allow the unit to sit for 8-10 hours before plugging in to allow the refrigerant to settle.
Installing the Handle
This appliance includes a stainless-steel handle that is not required to
operate this unit. To install the handle please follow the below instructions:
1. Pull away the door gasket in the area where the handle is to be
installed as shown in Illustration. The gasket is easily displaced by
hand, no tools are necessary.
2. Locate the screws included in the bag with the user's guide. Insert the
screws into the holes as shown.
3. Align the handle with the screws installed. Tighten the screws using a
Phillips head screwdriver until the handle sets both flush and secured
tightly against the door frame. (DO NOT over tighten as this will cause
damage to the handle assembly).
4. Replace the door gasket to its original position.
Reversing the Door Swing of your Appliance
CAUTION: Before reversing the door swing, please read and follow the reversal instructions below
carefully. Skipping steps might result in unexpected personal injury. To prevent serious
injury, wear eye and hand protection.
This unit has the capability of the door opening from either the left or right side. The unit is delivered
to you with the door opening from the left side. Should you desire to reverse the opening direction,
please follow the reversal instructions shown below.
NOTE: All parts removed must be saved to allow the door swing to be reversed.
Loading ...
Loading ...
Loading ...