Loading ...
Loading ...
Loading ...
9
1. Remove the parts from the packaging.
2. Clean your kettle by going through several boiling cycles, using clean water
with each cycle and filling the kettle to its upper marking. The water will
reach boiling point after approximately 5 minutes. The kettle switches off
automatically.
3. Discard the boiled water. Wait for the kettle to cool, then rinse it with cold
water.
4. Your appliance is now ready for normal use.
5. Dispose of the packaging in a responsible manner.
1. Fill the kettle using either the spout or lid. Open the lid by grasping it by the lid
handle and pulling it upwards and away from the main body of the kettle.
2. The water level must be between the MIN and MAX fill lines.
3. Check that the lid is closed correctly.
4. Ensure that the base unit and the base of your kettle are not wet.
5. Place the kettle onto the base unit and plug in.
6. Switch the kettle on by pressing down the On/Off switch located near the base
of the kettle to the On position.
7. The level indicator and On/Off switch will illuminate to indicate the kettle is in
operation.
Note: The ON/OFF switch will also automatically return to the OFF position when
it is finished boiling.
Note: You can stop the boiling process at any time by pushing the ON/OFF switch
up to the off position.
8. Ensure the kettle is switched off before removing it from its base. DO NOT
remove the kettle from its base while it is in operation.
9. If you need to boil the kettle again, wait for a few seconds - allow the On/Off
switch time to reset. The delay should be no more than 20 seconds.
10. When you lift the kettle up from the base, you may see drops of water on the
base. This is just condensation from steam.
11. To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
WARNING! NEVER REMOVE THE LID DURING BOILING.
IF THE WATER INSIDE THE KETTLE HAS JUST BOILED, THE KETTLE WILL BE FULL
OF STEAM. THE STEAM WILL ESCAPE AS SOON AS THE LID IS OPENED.
Tips: Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use.
Be economical and ecient and do not boil more water than you need.
4 - Before First Use
5 - Using Your Appliance
Loading ...
Loading ...
Loading ...