Loading ...
Loading ...
Loading ...
AFTEREACHUSE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. Follow these procedures after every
use:
1. Pressthe master ON/OFFswitch to the OFF(0) position.
Remove power cord plug from electrical outlet.
2. Turn off water supply, point gun in a safe direction, press
trigger lock button and squeezetrigger to relieve trapped
pressure.
3. Disconnect garden hose from the water supply and the
electric pressure washer.
4. Disconnect hose from spray gun and high pressure outlet
on pump. Drain water from hose, gun, and wand. Use a
rag to wipe off the hose.
5. Drain water from pump by tipping unit on its right side
(water inlet facing down).
6. Coil power cord and store on back of unit.
7. Store unit in a clean, dry area.
8. If storing for more than 30 days see Winter or Long Term
Storage on next page.
WINTERORLONGTERIViSTORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action.
Initial Storage Procedures
1. Drain detergent tank (if used) by tipping unit on its front
side and pouring out all remaining solution.
2. Run the electric pressurewasher with white tipped spray
tip. Flushfor one or two minutes.
3. Pressthe master ON/OFFswitch to the OFF(0) position.
Remove power cord plug from electrical outlet.
4. Turn off water supply. Point gun in a safe direction, press
trigger lock button and squeezetrigger to relieve trapped
pressure. After a few moments, releasetrigger on spray
gun.
5. Disconnect garden hose from the water supply and the
electric pressure washer. Disconnect pressure hose from
the pump and the spray gun.
6. Drain water from hoses and spray gun, then use a cloth
or equivalent to wipe off all exterior surfaces.
7. Ensurethat inlet and outlet hoses are disconnected from
the pump. Then drain water from pump by tipping unit on
its right side (water inlet facing down).
NOTICE Water left in the pump could freeze and damage the
pump.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver, Model 74403, to treat
pump. This prevents freeze damageand lubricates plunger
and seals.
NOTICE PumpSaveris available as an optional accessory, it
is not included with the electric pressure washer. Contactthe
nearestauthorized service center to purchase Pump Saver.
NOTICEYou must protect your unit from freezing
temperatures.
* Failureto do so will permanently damageyour pump
and render your unit inoperable.
* Freezedamage is not covered under warranty.
To use PumpSaver, make sure the electric pressure washer
is turned off and inlet and outlet hosesare disconnected.
Readand follow all instructions and warnings given on the
PumpSavercontainer.
Final Storage Procedures
1. Coil power cord and store on back of unit.
2. Store spray gun and accessories on back of unit.
3. Store unit in a clean, dry area that is protected from
freezing temperatures.
4. Cover unit with a suitable protective cover that does not
retain moisture.
13
Loading ...
Loading ...
Loading ...