Loading ...
Loading ...
Loading ...
Squaring Blade to Table for
Ripping
1. Unlock the swivel lock and turn the motor
to the out-rip position with the motor be-
tween the blade and fence. (Figure 63)
Fig. 63 - Out-rip Position
2. Lock swivel lock and rip lock.
3. Place the long edge of the framing square
on the table and the short edge against the
blade alongside the arbor sh@. Make sure
the square is against the surface of the blade
and not on the set of a tooth. (Figure 64)
4. Turn the blade v_ith your hand several
times and check to see if the square is flush
with the blade.
5. If the square is flush with the blade after
each rotation (Figure 65) go to step 11, or
If there is a gap between the square and the
blade after any rotation (Figure 65), go to
step 6.
i Right
Table Fence
Wrong )_.__F_ 1 Wrong _lu--<_
<rrM°t% r_t' If
Table ence Table Fence
Fig. 65
6. Loosen the hex nut on the rear carriage
bearing. Use a 9116 inch wrench to hold the
bolt and a 1/2 inch wrench to loosen the nut.
(Figure 66)
Fig. 66
Fig. 64
27
Illlllllll
Loading ...
Loading ...
Loading ...